Make 6 Term Electricity System Audio Flow Prima

 KOMPAS.com - The car that was equipped with audio devices that would require too much extra electricity. If still rely on standard batteries, then it makes the supply is not prime.
For example, a car has an innate 12-volt battery with 30 amps of current. This means that the power generated is 360 watts. In other cases, the car is already using watt halogen lamps with large. In addition, the power amplifier to boost the audio system installed in the cabin. If it is assumed, 260-watt halogen lamps, horns 140 watts, and 300-watt power amplifier, then the total is 700 watts. Meanwhile, the power that belongs to 360 watts. This means that less than 340 watts. As a result, the battery quickly come up short.
There are 6 requirements for electrical systems flowing vibrant audio.
• Alternator. These components must be able to fill the battery. For that, consider the cleanliness of the cables. If you already use the spec for the SPL, alternator replacement must be done so that the system can be used to supply a large electric current.
• Aki. When equipped with an audio system, this meant adding electrical load, let alone rely on the power of audio. If previously used 40 amps of battery, then replace the battery now with the size of 60 amperes.
• battery cable. According to the boss Radius Audio, Bandung, Erwin Kosasih, the greater the size of the battery cable, then the better because of the easier flow of electric current. More importantly, the positive and negative wires must be equal.
• Cable "Ground". Ground the chassis must be sanded before the negative cable installed. Usually, the best and strongest point is the position seatbelt. Adding ground wire is very effective to make a stable electric current. This means that, from the negative battery, it can be channeled into the body, engine, alternator negative, and others.
• "Cap Bank". This device was also good to realize the current role is stable. Through functional component temporarily stores these currents, electricity will always be well distributed. Counts for the bank stamp, 1 Farad to 1000 watts. For extra security, use spek 2 Farad.
• "Batcap". If you want more stable electric current again, could use batcap Xstatic. This product consists of several types, namely, X300, X400, X800, and x2000. These components combine battery and a bank stamp. With a large reservoir, the flow of out great, stable, and fast. (Grace, Tomo) source: www.kompas.com

thank you for your visit

Posted in: tips and tricks